Benji'$ $chooL Are you looking for a place to stay? What about Granada, Nicaragua. call: 011-505-896-7514 or 011-505-885-5443. E-mail:evertsfnic@hotmail.com
Google
 
Web vacation in nicaragua
Setting Up W
Before
Additional
Your Computer
The Internet
Connecting
Web Surfers
E-Mail
Hard Disk
Installation
Prepared
Considerations
Startup Disk
Partition
Fdisk
Formatting
General Inf..
Startup
Support(FAT32)
Accessibility
Frequently ?
Compression
Modems
FAT32
Tips - Tricks
Maintenance
SendTo
Taskbar
Properties
MS-DOS
Bienvenidos a Nicaragua
Bienvenidos a Nicaragua
Bienvenidos a Nicaragua
Bienvenidos a Nicaragua
Bienvenidos a Nicaragua
Bienvenidos a Nicaragua
To check the port settings:
  • Click Start, point to Settings, and then click Control Panel.
  • Open Modems. If you don't see the Modems icon, click View All Control Panel Options.
  • Select your modem, and then click Properties.
  • Click the Connection tab to check the current port settings such as baud rate, data bits, stop bits, and parity.
  • Click Advanced to check error control and flow control. If you are using Windows 16-bit-based programs, turn off these advanced features.
  • Verify the UART type.

    Data transmission problems may occur if your computer is performing other tasks during a file download. If problems or errors occur during transmission, try lowering the baud rate. Attempts to use baud rates greater than 9600 on computers equipped with 8250 or 16450 UARTs will probably result in dropped characters.

    To check the modem baud rate:

  • Click Start, point to Settings, and then click Control Panel.
  • Open Modems. If you don't see the Modems icon, click View All Control Panel Options.
  • Select your modem, and then click Properties.
  • In the Maximum Speed area on the General tab, set the baud rate to the correct speed. Slower modem speeds may work, especially if you are using an older computer.
  • Make sure the Only Connect At This Speed check box is selected.

    NOTE: If the host system you are calling cannot communicate at the initial baud rate, it may be able to communicate at a slower baud rate.
    TIP: To optimize communications performance, set the baud rate to a higher speed.

    To disable hardware flow control if your modem cable doesn't support it:

  • Click Start, point to Settings, and then click Control Panel.
  • Open Modems. If you don't see the Modems icon, click View All Control Panel Options.
  • Select your modem, and then click Properties.
  • Click the Connection tab, and then click Advanced.
  • Make sure the Use Flow Control check box is cleared.


    «           »

    • 011-505-885-5443 evertsfnic@hotmail.com Granada. Km44. Reparto San Juan. Lote #5